When it comes to bathroom design, hardware products play a crucial role. Proper installation of bathroom hardware should consider ergonomics, align with daily living habits, and make the space more user-friendly. Today, as we move into an era where bathroom fixtures are not only functional but also energy-efficient and water-saving, it's essential to understand the basics of installation. In this article, I’ll walk you through the order and key techniques for installing bathroom hardware.
The Installation Sequence of Bathroom Hardware
Start by tiling the walls, then install the ceiling, followed by laying the floor tiles. After that, mount the toilet, sink, and bathtub. Next, connect the drains, install lighting, sockets, and mirrors, and finally add towel bars and other hardware accessories.
Step-by-Step Toilet Installation
Begin by checking the floor drain pipe, aligning the outlet, leveling, marking the position, drilling the hole, applying putty, placing the rubber gasket, tightening the nut, positioning the tank on the back wall, inserting the bolt, and securing everything in place. Then install the water elbow and the flush valve, ensuring all parts are properly adjusted and tightened.
Washbasin Installation
Insert expansion bolts, tighten them, hang the support rack, place the sink on the rack, and check for levelness. Connect the water supply, straighten the pipes, and secure the connections.
Tub Installation
Install the water inlet, close the opening tightly, and ensure the tub is level and properly secured.
Installation Tips for Better Results
Handle Installation: Handles should be installed in a way that’s comfortable and easy to use. For consistency, all handles on the same cabinet should be aligned neatly. The length of screws must match the thickness of the door or drawer panel. When drilling, the hole size should match the screw diameter exactly.
Door Hinge Installation: Most standard doors use two 100mm hinges. However, if the door is solid or has a curved or recessed design, three hinges may be needed, or two 125mm hinges for better support.
Lock Installation: Once the lock is installed, the handle should be positioned between 900–1000mm from the floor. Start by mounting the lock body and latch, ensuring the latch plate is flush with the door edge. Close the door, mark the position, and then install the lock plate so that it sits smoothly against the door frame.
Hot Plate,Electric Hot Plate,Heating Plate,Double Hot Plate
Zenith Lab (Jiangsu) Co.,Ltd , https://www.zenithlabo.com