Horizontal band sawing machine is mainly used for sawing alloy structural steel, medium carbon steel, low alloy steel, heat resistant steel SKT, high alloy steel, special alloy steel and stainless steel, bearing steel, acid resistant steel, straightening steel and other metals. material.
Horizontal band sawing machine classification:
According to the horizontal structure, it is divided into scissors, double column and single column band sawing machine;
According to the use situation, it is divided into manual type (economic manual feeding manual cutting material) and automatic type;
According to the automatic program using the controller, it can be divided into manual type (semi-automatic manual feeding) automatic type (automatic feeding automatic cutting);
According to the cutting angle requirements, it can be divided into angle sawing machine (can be sawed at an angle of 90 degrees and 45 degrees) without angle or 90 degree vertical cutting. 1. Sawing angle adjustment: If you want to cut any angle within a 45 degree angle, first loosen the fixed handle, then push the saw bow clockwise, aiming at the angle scale you need on the angle scale on the seat. On, lock the handle firmly. 2. When you adjust the sawing angle, the angle of the small vise needs to be adjusted to loosen the vise fixing screw, and then push the small vise to the big vise, so that the small vise and the big vise have the same angle, after locking the fixing screw Just fine.
Saw belt selection: 1, the life of the same saw belt is mainly determined by a suitable depth of the knife, and the depth of the knife is determined by the size of the saw, the cutting speed (saw speed), the cutting force (the cutting speed of the saw bow), and the undercut The pressure is determined. 2, the size of the tooth saw - the saw blade tooth saw is too large and the number of teeth is small, which will make the cutting unstable, and because the cutting load of each saw tooth increases, it is easy to cause the sawtooth to be toothed and collapsed. If the saw is too small, it is prone to sawdust clogging and wear and damage soon after use. When cutting a workpiece with good toughness and softness, use a thick sawtooth saw band as much as possible. If you want a good cutting surface, choose a fine sawtooth saw band.
Concerned about surprises
Label: Type of horizontal band saw
Previous: What are the application areas of valves? Next: Characteristics of zinc steel balcony railings
Diamond Hand Polishing and Grinding Pads manufactured using diamond flexible material for use on edges, corners and flat surfaces of a wide range of materials such as granite, marble, engineered stones, glass, ceramics, composites and hard metals. are used for polishing, grinding, restoring/cleaning areas hard to reach by polishing tools like wet grinder polisher, angle grinder etc. A useful and handy diamond tool to polish corners, contoured surface like sink, join of two bullnose surface for Granite polishing, Concrete polishing, Marble polishing, Terrazzo polishing, Travertine polishing, glass polishing and their restoration etc. These diamond tools may be used for floor polishing, counter top polishing, stone sculpture polishing etc. It could be useful and cost saver for small polishing project. Hand polishing could be time consuming over polishing using tools like grinders etc.
Hand Pads - Standard
80x50mm, 90 x 55mm and 120 x 60mm
Metal Grades Resin Grades
-60-1200 grit - 800-12000 grit
Metal Grades Resin Grades
-60-1200 grit - 800-12000 grit
Diamond Hand Pads,Diamond Hand Polishing and Grinding Pads,Diamond Hand Polishing Pads,Plated - Hand Pads - Hand Grinding,Flexible Diamond Hand Lap,Iamond Polishing Pads
Hans Superabrasive Material Co., Ltd. , http://www.hansuperabrasive.com