How to install plastic PE storage tank and joint connection precautions

If there is any doubt, you can call or visit the company at any time! Http:// How to install the inlet and outlet connectors of plastic PE storage tanks? Which kind of joints should be installed for different media storage? How to solve the problem of sealing between flange joints? What should you pay attention to when connecting the connector? Is this series of questions a mess? It doesn't matter, the following small series will give you one by one to answer!

1. The basic requirements for installing the tank are flat and can withstand the corresponding pressure.
2. Place the tank in place, please remove any sharp objects or stones.
3. The tank has been installed at the factory, and the strength is the best. However, the joint may be loosened during transportation, loading and unloading, and the joint sealing performance should be checked during installation. Please note that the joint is a finished product made of resin such as PE, PVC, ABS or nylon. If it is tightened too tightly, the thread may be damaged.
4. The external connection of the tank must be correct. The pipe connected to the lower joint or flange of the tank shall be perpendicular to the tank wall. In special cases, soft over-connection is recommended to avoid the vertical change or expansion of the tank wall after filling with liquid, resulting in leakage of the joint connection damaged product. In severe cases, it affects the service life of joints and barrels.
5. After the piping work is finished, be sure to apply full water pressure test to confirm the presence of water leakage. If there is any water leakage, please check the seal and threaded part of the joint for any error and adjust it separately.
6, PE storage tank memory solution temperature is generally -20 ° C ~ 60 ° C. If the temperature of the liquid is higher than 60 °C, a metal reinforcing sleeve should be arranged to prevent the tank from softening and deforming.
7. When storing chemical materials (specific gravity greater than 1:2) or tanks of more than 30 cubic meters, a metal reinforcing sleeve can be used to limit the expansion deformation of the barrel body, thereby avoiding cracking of the barrel hole.
8. This storage tank is a general-purpose container. Do not add internal pressure or external pressure to the storage tank. When the inflow and discharge flow rates are large, the vent holes of the corresponding flow should be configured.

The above points clearly illustrate the several problems that need to be paid attention to in the above PE storage tanks. I hope that the users can get familiar with them. If there are any doubts, you can call or consult the company at any time! Http://://news.chinawj.com.cn How to install plastic PE storage tank and joint connection precautions Editor: (Hardware Business Network Information Center) http://news.chinawj.com.cn How to install plastic PE storage tank and joint connection precautions

Silicone Tea Infuser

Tea Strainer Silicone,Silicone Tea Strainer,Silicone Tea Bag Infuser,Silicone Tea Steeper

YANGJIANG VOSSEN INDUSTRY AND TRADE CO.,LTD , https://www.cnvossen.com