1, the reference amount of activated carbon
Newly renovated living rooms (including office space, hotels, etc.) are used at 1-2 packs per square meter (ie 50-100g). The daily protection of the indoor environment can be appropriately reduced according to the degree of pollution.
(Note: 50-100g per square meter is used to calculate the total amount of space used, not to evenly place 50-100g per square meter.)
2, the use of activated carbon:
A. The key place is the source of pollution and the place where people often move. The activated carbon adsorption package is directly placed in the cabinet of the wardrobe, shoe cabinet, book cabinet, kitchen cabinet, etc. in the living room; the computer, the desk, the coffee table, the sofa, and other places where people often move, and any other places that need to purify the air. Activated carbon is a passive purification material. The harmful substances in the air must rely on air as a medium, but the air mobility in the room is poor. The activated carbon is difficult to capture harmful substances in the air far away in a short time, so it is used in a small range. Small spaces work best.
B. The height of the space is 180 cm. Indoor harmful gas, taking formaldehyde as an example, its specific gravity is greater than air, so the pollutants in the middle and lower parts of the indoor space are the most serious. This height is equivalent to the height of the human body, so it is the best placement height.
C. After about 20 days of use, after 3-5 hours of exposure in the sun, it can be used repeatedly, so it can be used for 6-10 months. This step is necessary. The pores in the activated carbon are limited and will be saturated after a period of use. In particular, a large amount of water molecules occupy a large space in the activated carbon. Therefore, it is necessary to explode on a regular basis to evaporate water molecules in the activated carbon.
D. Use of new homes that do not stay immediately: first open the windows to ventilate as much as possible. You can use an electric fan to speed up the alternating amount of fresh air and indoor air, discharge harmful gases to the outside, and disperse the activated carbon adsorption pack anywhere in the room. After a period of time, the indoor odor is alleviated, and the activated carbon is collected and placed in a centralized manner to control the source of pollution and continuously adsorb harmful substances that are continuously released. When the activated carbon is placed in the cabinet, the door should be closed and the window opened.
E, the need to stay in the new house to pay attention to points: the principle of physical adsorption of activated carbon is like the regulation principle of traditional Chinese medicine, the effect is slightly slow, but safe without side effects, long-lasting purification time. For new homes that are urgently needed, it is recommended to use them in combination with other treatment methods, such as using plant decontamination methods: placing plants such as spider plant, tiger-tail orchid, aloe vera; or using plant extract as a raw material for pollution control products (eg herbal aldehyde) Spirit, etc.).
3. Try to keep the window open and ventilated during use.
(Note: Explanation of pollution source - indoor decoration pollution is mainly formaldehyde pollution, and the main release source of formaldehyde is the place where large fiber board and core board are accumulated.)
Introduction Of Product
JESSRO CPVC PIPE&FITTINGS SYSTEM which have excellent heat resistance and high impact can be used to covey cold and hot water with or without pressure. They are widely used in housing, hotel, springs, ktchen, bath and solar water heater water transfering systems with no rusting, no limescale and long life time.
Features Of Product
Widely used in housing, hotel, springs, ktchen, bath and solar water heater water transfering systems.
Heat resistance and high impact.
Light, durable ,convenient.
Saving cost and accelerating the project for the easy installation.
Way Of Conection
First step, clear both end of the pipe fittings.
For socket type, there need to use the corresponding glue on the socket wall again with the pipe and stick them together.
For screw type, there need to use teflon tape winding outer thread screw parts, then smooth twist in the threaded.
Scope Of Application
Wter project in construction.
Water treatment for swimming pool.
Water treatment in chemical industry.
CPVC Pipe & Fittings System can be applied to the following
|
|
|
|
|
CPVC Pipe Fittings, Plastic Pipe Fitting, CPVC Piping
JESSRO INDUSTRY CO., LTD. , http://www.pepipefittings.com